Photovoltaic module shipments surge in the fourth quarter of 2012

A new PV module shipment record of 11 GW was reached in the fourth quarter.

01/15/2013


IHS After a disastrous third quarter of 2012 featuring extremely low factory utilization rates across the entire photovoltaic (PV) supply chain, a surge in demand was seen in the final quarter of the year for PV modules. A new PV module shipment record of 11 GW was reached in the fourth quarter according to the IHS Solar Integrated Market Tracker from information and analytics provider IHS. Despite this positive sign the situation of the global PV industry remains critical and a substantial recovery of the supply-demand balance is not expected to occur before the second half of 2013.

PV markets rebound sharply in the fourth quarter of 2012

The third quarter of 2012 dealt another blow to the global photovoltaic industry. After a relatively strong second quarter resulting in global installations of 7.8 GW, markets softened again. “Installations in the third quarter amounted to just 7.5 GW. Wholesalers, EPCs, and PV suppliers were forced to carefully control their inventory levels due to falling prices and low shipment levels and production cuts were the consequence,” commented Principal Analyst Stefan de Haan. In the third quarter of 2012, average module capacity utilization fell to 49 percent, cell capacity utilization to 56 percent, wafer capacity utilization to a record-low 55 percent, and polysilicon capacity utilization to 63 percent. In parallel, prices continued their slide in the third quarter of 2012 resulting in module industry revenues of only $6.0 billion—the lowest value since the second quarter of 2009. These difficult conditions were reflected in an increasing number of suppliers exiting the market.

“In the fourth quarter of 2012 global PV markets rebounded sharply. Very strong demand from Asia, with the surge driven largely by China and Japan, helped to compensate for sluggish demand in Europe. IHS estimates that global PV installations were 10.1 GW in the fourth quarter of 2012. In particular leading Chinese module suppliers benefited from the uptick in demand and shipped much more than previously expected,” explained de Haan. In total, 11.0 GW of global module shipments are estimated for the fourth quarter of 2012 - a new record for the industry. As anticipated by IHS, average market pricing for crystalline modules declined to $0.65 per watt at the end of 2012, down from $0.70 at the end of September. Importantly, however, the price decline lost momentum in the course of the fourth quarter. Towards the end of the year some module prices even increased. Record-level shipments paired with stabilizing prices drove a profound recovery of revenues. According to the IHS Solar Integrated Market Tracker, fourth quarter 2012 module revenues grew by a stunning 42 percent quarter-over-quarter, reaching $8.5 billion.

Suppliers will experience seasonal weakness in the first quarter of 2013

In the first quarter of 2013 suppliers are predicted to experience the usual seasonal weakness of global solar markets. Global PV installations are forecast to drop to 6.7 GW in this quarter. As a result upstream shipments and revenues will temporarily come under pressure again. With prices forecast to decrease by another 4 -5 percent in the first quarter of 2013 (compared to the fourth quarter of 2012), module revenues will fall back to the critical levels of the third quarter of 2012—or even below. This will force more suppliers to review their business models and eventually leave the solar market.

2013 will be the year of the turnaround

After a tough first quarter, a substantial increase in global demand is forecast to drive increasing revenues and stabilizing prices in the second half of 2013. IHS forecasts 35 GW of global installations in 2013, up 10 percent over 2012. Although this level of growth is lower than previous years, it will drive a continuous improvement of shipments and revenues in the polysilicon to module supply chain throughout 2013. Recent positive signals from authorities in several key markets like China and France raise hopes for the recovery of the PV industry to happen even faster. “Whilst it’s too early to give the all-clear for the PV supplier industry, there is increasing indication that the year 2013 will mark the turnaround,” concluded de Haan.

The chart below presents a forecast of global shipments of the photovoltaic module industry (crystalline and thin film).

Source: IHS January 2013



Top Plant
The Top Plant program honors outstanding manufacturing facilities in North America.
Product of the Year
The Product of the Year program recognizes products newly released in the manufacturing industries.
System Integrator of the Year
Each year, a panel of Control Engineering and Plant Engineering editors and industry expert judges select the System Integrator of the Year Award winners in three categories.
June 2018
2018 Lubrication Guide, Motor and maintenance management, Control system migration
May 2018
Electrical standards, robots and Lean manufacturing, and how an aluminum packaging plant is helping community growth.
April 2018
2017 Product of the Year winners, retrofitting a press, IMTS and Hannover Messe preview, natural refrigerants, testing steam traps
June 2018
Machine learning, produced water benefits, programming cavity pumps
April 2018
ROVs, rigs, and the real time; wellsite valve manifolds; AI on a chip; analytics use for pipelines
February 2018
Focus on power systems, process safety, electrical and power systems, edge computing in the oil & gas industry
Spring 2018
Burners for heat-treating furnaces, CHP, dryers, gas humidification, and more
April 2018
Implementing a DCS, stepper motors, intelligent motion control, remote monitoring of irrigation systems
February 2018
Setting internal automation standards

Annual Salary Survey

After two years of economic concerns, manufacturing leaders once again have homed in on the single biggest issue facing their operations:

It's the workers—or more specifically, the lack of workers.

The 2017 Plant Engineering Salary Survey looks at not just what plant managers make, but what they think. As they look across their plants today, plant managers say they don’t have the operational depth to take on the new technologies and new challenges of global manufacturing.

Read more: 2017 Salary Survey

The Maintenance and Reliability Coach's blog
Maintenance and reliability tips and best practices from the maintenance and reliability coaches at Allied Reliability Group.
One Voice for Manufacturing
The One Voice for Manufacturing blog reports on federal public policy issues impacting the manufacturing sector. One Voice is a joint effort by the National Tooling and Machining...
The Maintenance and Reliability Professionals Blog
The Society for Maintenance and Reliability Professionals an organization devoted...
Machine Safety
Join this ongoing discussion of machine guarding topics, including solutions assessments, regulatory compliance, gap analysis...
Research Analyst Blog
IMS Research, recently acquired by IHS Inc., is a leading independent supplier of market research and consultancy to the global electronics industry.
Marshall on Maintenance
Maintenance is not optional in manufacturing. It’s a profit center, driving productivity and uptime while reducing overall repair costs.
Lachance on CMMS
The Lachance on CMMS blog is about current maintenance topics. Blogger Paul Lachance is president and chief technology officer for Smartware Group.
Electrical Safety Update
This digital report explains how plant engineers need to take greater care when it comes to electrical safety incidents on the plant floor.
Maintenance & Safety
The maintenance journey has been a long, slow trek for most manufacturers and has gone from preventive maintenance to predictive maintenance.
IIoT: Machines, Equipment, & Asset Management
Articles in this digital report highlight technologies that enable Industrial Internet of Things, IIoT-related products and strategies.
Randy Steele
Maintenance Manager; California Oils Corp.
Matthew J. Woo, PE, RCDD, LEED AP BD+C
Associate, Electrical Engineering; Wood Harbinger
Randy Oliver
Control Systems Engineer; Robert Bosch Corp.
Data Centers: Impacts of Climate and Cooling Technology
This course focuses on climate analysis, appropriateness of cooling system selection, and combining cooling systems.
Safety First: Arc Flash 101
This course will help identify and reveal electrical hazards and identify the solutions to implementing and maintaining a safe work environment.
Critical Power: Hospital Electrical Systems
This course explains how maintaining power and communication systems through emergency power-generation systems is critical.
click me