Stepper drive: OEM controller/driver adds CANopen
QuickSilver added a CANopen option to its smallest closed-loop stepper-motor controller.
QuickSilver added a CANopen option to its smallest (52 mm x 63 mm) closed-loop stepper-motor controller. The company says CANopen can be configured for peer-to-peer, master or slave, which allows the controllers to share I/O and registers with other CANopen-enabled SilverDust controllers or 3rd party CANopen devices (such as I/O blocks, encoders, and PLCs). For a multi-axis system, the company suggests, connect several MG-Cs, make one the master and let the others receive motion commands over CANopen.
This single axis, programmable controller/driver is specially designed to servo third party stepper motors, according to the company, creating a closed loop stepper system. The unit also includes serial communications (RS-232, RS-485), and seven digital I/O lines. The RS-232/RS-485 serial network runs independently in parallel to CAN for supervisory control from a host.
The seven bi-directional I/O lines, 12-48 V input power, and communications signals are accessed through a DB15HD port and can be separated using one of the company’s breakouts (QCI-BO-B, QCI-BO-B1, QCI-BO-B1A).
— edited by C.G. Masi , senior editor, Control Engineering News Desk
Register here and scroll down to select your choice of eNewsletters free.
- Events & Awards
- Magazine Archives
- Oil & Gas Engineering
- Salary Survey
- Digital Reports
Annual Salary Survey
After almost a decade of uncertainty, the confidence of plant floor managers is soaring. Even with a number of challenges and while implementing new technologies, there is a renewed sense of optimism among plant managers about their business and their future.
The respondents to the 2014 Plant Engineering Salary Survey come from throughout the U.S. and serve a variety of industries, but they are uniform in their optimism about manufacturing. This year’s survey found 79% consider manufacturing a secure career. That’s up from 75% in 2013 and significantly higher than the 63% figure when Plant Engineering first started asking that question a decade ago.