Iran fires up nuke plant, connects to grid

If you think nuclear plant construction here is slow, Iran’s pace is glacial but after 35 years has finally come full term.


Iran has finally entered the atomic age, publically at least, as its one and only more-or-less finished nuclear power plant connects to the grid. The Bushehr (strictly peaceful) nuclear power plant is about 750 miles south of Tehran on the Persian Gulf, and is a 1,000 MW, (presently) single unit facility. Originally the plan was to have four units on this site, but as of now the plan has been pulled back to three, which may still be wishful thinking. There have been many premature reports that it is just about ready to go online any minute now, but this time it looks like it’s legit, running at low power and ramping up to hit 40% of total output by next week.

   Construction on this plant began in 1975 led by Siemens and a group of other German companies back when the Shah was still in power. (Raise your hand if you’re old enough to remember the Shah.) Apparently he was looking ahead to the time when oil would be too expensive for use as a fuel, and had plans to build 23,000 MW of nuclear generating capacity. Things ground to a halt after the revolution in 1979. Siemens and its syndicate abandoned the project leaving two units under construction. Things sat quietly corroding in the hot salty air by the gulf, with occasional bombing damage during the Iran-Iraq war in the mid-1980s.

   The Iranians brought in a Russian group to start construction again in the mid-1990s, and work started slowly with the expectation of completion by 2001. The site quickly became a hodge-podge of equipment as Atomstroyexport decided to use its reactor design along with some of the remaining Siemens equipment. The international community in general wasn’t excited about the prospects, and Russia was having its own internal problems during that time, so it all got pretty complicated politically. Still, negotiations continued, and by 2005, the U.S. withdrew its official opposition to the project and things were stable enough with the Russians for things to begin again in earnest. Now it’s ready to go.

   While I think nuclear power is a pretty good idea in most situations, this one seems a little scary. Let’s accept for the sake of argument that this facility does not offer support for Iran’s desire to create weapons-grade nuclear material. We’ll also assume that Russian operators and trainers are on site to keep things on an even keel, running a Soviet-era reactor design. It still gives me the heebie geebies. This is just one more reason I’m glad I don’t live over there.

No comments
The Top Plant program honors outstanding manufacturing facilities in North America. View the 2015 Top Plant.
The Product of the Year program recognizes products newly released in the manufacturing industries.
The Engineering Leaders Under 40 program identifies and gives recognition to young engineers who...
Safety for 18 years, warehouse maintenance tips, Ethernet and the IIoT, GAMS 2016 recap
2016 Engineering Leaders Under 40; Future vision: Where is manufacturing headed?; Electrical distribution, redefined
Strategic outsourcing delivers efficiency; Sleeve bearing clearance; Causes of water hammer; Improve air quality; Maintenance safety; GAMS preview
SCADA at the junction, Managing risk through maintenance, Moving at the speed of data
Safety at every angle, Big Data's impact on operations, bridging the skills gap
The digital oilfield: Utilizing Big Data can yield big savings; Virtualization a real solution; Tracking SIS performance
Applying network redundancy; Overcoming loop tuning challenges; PID control and networks
Driving motor efficiency; Preventing arc flash in mission critical facilities; Integrating alternative power and existing electrical systems
Package boilers; Natural gas infrared heating; Thermal treasure; Standby generation; Natural gas supports green efforts

Annual Salary Survey

Before the calendar turned, 2016 already had the makings of a pivotal year for manufacturing, and for the world.

There were the big events for the year, including the United States as Partner Country at Hannover Messe in April and the 2016 International Manufacturing Technology Show in Chicago in September. There's also the matter of the U.S. presidential elections in November, which promise to shape policy in manufacturing for years to come.

But the year started with global economic turmoil, as a slowdown in Chinese manufacturing triggered a worldwide stock hiccup that sent values plummeting. The continued plunge in world oil prices has resulted in a slowdown in exploration and, by extension, the manufacture of exploration equipment.

Read more: 2015 Salary Survey

Maintenance and reliability tips and best practices from the maintenance and reliability coaches at Allied Reliability Group.
The One Voice for Manufacturing blog reports on federal public policy issues impacting the manufacturing sector. One Voice is a joint effort by the National Tooling and Machining...
The Society for Maintenance and Reliability Professionals an organization devoted...
Join this ongoing discussion of machine guarding topics, including solutions assessments, regulatory compliance, gap analysis...
IMS Research, recently acquired by IHS Inc., is a leading independent supplier of market research and consultancy to the global electronics industry.
Maintenance is not optional in manufacturing. It’s a profit center, driving productivity and uptime while reducing overall repair costs.
The Lachance on CMMS blog is about current maintenance topics. Blogger Paul Lachance is president and chief technology officer for Smartware Group.
This article collection contains several articles on the vital role of plant safety and offers advice on best practices.
This article collection contains several articles on the Industrial Internet of Things (IIoT) and how it is transforming manufacturing.
This article collection contains several articles on strategic maintenance and understanding all the parts of your plant.
click me