Increasing motor efficiency with power factor control
Maximizing energy efficiency of a motor drive application using classic, interleaved power factor control (PFC).
Electric motors account for 65% to 70% of industrial electrical energy consumption and approximately 57% of all electrical consumption worldwide. Therefore, electronic designers of are now looking into maximizing the energy efficiency of a motor drive application using power factor control (PFC). Using an electronic drive to regulate the output speed of the motor for the mechanical load required, with PFC improves efficiency of the drive by correcting the out of phase voltage and current being used.
Classic PFC circuits used in many drive applications have been the single boost topology. Recently, interleaved power factor has gained much interest in the drive community. Each PFC topology has distinct benefits.
As the industrial market looks to replace old inefficient motors, and new equipment manufacturers try to make use of better variable speed motor solutions, high efficient drives will be the solution. Manufacturers that offer motor drives with power factor control will be able to work with OEM customers meeting the needs of energy efficiency, low installation cost, and flexibility.
- Edited by Gust Gianos, Control Engineering, www.controleng.com
- Events & Awards
- Magazine Archives
- Oil & Gas Engineering
- Salary Survey
- Digital Reports
Annual Salary Survey
After almost a decade of uncertainty, the confidence of plant floor managers is soaring. Even with a number of challenges and while implementing new technologies, there is a renewed sense of optimism among plant managers about their business and their future.
The respondents to the 2014 Plant Engineering Salary Survey come from throughout the U.S. and serve a variety of industries, but they are uniform in their optimism about manufacturing. This year’s survey found 79% consider manufacturing a secure career. That’s up from 75% in 2013 and significantly higher than the 63% figure when Plant Engineering first started asking that question a decade ago.